Skip to content Skip to footer

Circuit board adaptor allows creation of multi-pin connector on printed circuit board

Share on facebook
Share on twitter
Share on linkedin

Circuit board adaptor allows creation of multi-pin connector on printed circuit board

HARTING has introduced a new 5-pin circuit board adaptor which, when combined with a Han® DDD module from the company’s proven Han-Modular® series, makes it possible to create a multi-pin connector on a printed circuit board.

The circuit board adapter can be pre-assembled on the PCB by following the hole pattern. A 17-pin circuit board connection is then created for the Han® DDD module through the connection of two 6-pin adaptors and the new 5-pin circuit board adaptor.

The adaptor can be assembled onto the PCB independently of the connector. After assembly of the PCB, the male or female contact of the Han® DDD module is installed in the housing and attached on the pre-assembled PCB. Simple assembly is not the only advantage: the labour involved in wiring is also kept to a minimum.

For connection to the circuit board, 17 contacts are available, with the rated values (as per the DIN EN 61984 standard) of 7.5 A for current, 160 V for voltage, and 2.5 kV rated surge voltage at pollution grade 3.

With this new development, HARTING’s Han-Modular® series is expanded with a new variety of PCB adapter in addition to the existing Han® DD solutions and the Han® 40 A module.

With the open Han-Modular® connector system, users can assemble customised connectors to their own individual requirements. Over 40 different modules are available for electrical, optical and pneumatic transmission.

 

HARTING Limited

Tel: +44 (0) 1604 827500

 

 

gb@harting.com

www.harting.co.uk

 

 

 

Show CommentsClose Comments

Leave a comment